[yocto] Build qemuarm compatible with freescale i.MX6

[Federico Vitali]

Thank you Marco.
so I can run a generic arm qemu kernel with the image created for my sabre
sd card?
I suppose I have to make a qemu armv7 kernel, am I wrong? In that case how
can I
configure my local.conf to make a qemu armv7 kernel?

Thank you again


2014-02-28 14:53 GMT+01:00 Marco <koansoftware at gmail.com>:

> Il 28/02/2014 11:03, Federico Vitali ha scritto:
>
>> Goodmorning,
>>
>>
>> I'm new to yocto project, I would like to know if there is the
>> possibility to build a qemuarm
>> kernel compatible with fsl i.MX6. I'm developing with a sabre SD board
>> and I would like to
>> run the same filesystem both on the real target and via qemu emulation
>> on my PC for application
>> developement purposes.
>>
>> Thank you in advance to anyone who wants to contribute!
>>
>>
>
> Federico,
> AFAIK the kernel can't be the same and moreover iMX6 generated system will
> use hw graphic acceleration, so probably couldn't be the same.
> You can use a generic ARM kernel on qemuarm and a specific one on iMX6
> with the same image type though.
>
> Ciao
> --
> Marco Cavallini | KOAN sas | Bergamo - Italia
>  embedded and real-time software engineering
> Phone:+39-035-255.235 - Fax:+39-178-22.39.748
>       http://www.KoanSoftware.com
> _______________________________________________
> yocto mailing list
> yocto at yoctoproject.org
> https://lists.yoctoproject.org/listinfo/yocto
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.yoctoproject.org/pipermail/yocto/attachments/20140228/a27518e5/attachment.html>