[yocto] Connecting to target using eclipse/ADT

[Zhang, Jessica]

So if you can tell the hello world program is transferred to the remote target successfully, I'm assuming that you can access the remote target.  So on it, can you grep the running process and see whether there's tcf-agent?

-----Original Message-----
From: emirelkholy at gmail.com [mailto:emirelkholy at gmail.com]
Sent: Tuesday, May 22, 2012 1:37 PM
To: Zhang, Jessica
Cc: yocto at yoctoproject.org
Subject: Re: [yocto] Connecting to target using eclipse/ADT

Hello,
I can ping my target with no problem, and when I tried to debug a hello world program it transferred the hello world file the target. The connection just timed out so I was unable to debug through eclipse. How can I check to verify the tcf agent is running on thr target? Do you have instructions?

Thanks,
Emir



On May 22, 2012, at 4:23 PM, "Zhang, Jessica" <jessica.zhang at intel.com> wrote:

> So do you have access to your target at all? Can you verify that the tcf-agent is up running on the target device?
>
> -----Original Message-----
> From: yocto-bounces at yoctoproject.org [mailto:yocto-bounces at yoctoproject.org] On Behalf Of Emir Elkholy
> Sent: Tuesday, May 22, 2012 11:58 AM
> To: yocto at yoctoproject.org
> Subject: [yocto] Connecting to target using eclipse/ADT
>
> When connecting to my CRB that is running off a usb drive that has yocto on it I am trying to connect to the CRB from my host in order to debug using TCF agent. Through eclipse I am entering the IP address of the target, and attempting to debug from the debug configurations menu. Using a simple helloworld as an example, the file is actually transferred to the target CRB, but the debugging fails. Eclipse gives me a connection timing out error (not allowing me to debug). Is there a link that describes how to connect to a physical target using eclipse and the ADT? Is there anything that must be done on the target side first before attempting to debug? I only enter the IP address of the target under debug configurations, I don't setup anything on the target side, maybe this is the problem? I followed the same procedure as connecting to the QEMU (which works) as I did with the physical hardware. I can't find anything online about a connection time out either.
>
> Thanks
> _______________________________________________
> yocto mailing list
> yocto at yoctoproject.org
> https://lists.yoctoproject.org/listinfo/yocto