[yocto] Connecting to target using eclipse/ADT

[emirelkholy at gmail.com]

Hello,
I can ping my target with no problem, and when I tried to debug a hello world program it transferred the hello world file the target. The connection just timed out so I was unable to debug through eclipse. How can I check to verify the tcf agent is running on thr target? Do you have instructions?

Thanks,
Emir



On May 22, 2012, at 4:23 PM, "Zhang, Jessica" <jessica.zhang at intel.com> wrote:

> So do you have access to your target at all? Can you verify that the tcf-agent is up running on the target device?
> 
> -----Original Message-----
> From: yocto-bounces at yoctoproject.org [mailto:yocto-bounces at yoctoproject.org] On Behalf Of Emir Elkholy
> Sent: Tuesday, May 22, 2012 11:58 AM
> To: yocto at yoctoproject.org
> Subject: [yocto] Connecting to target using eclipse/ADT
> 
> When connecting to my CRB that is running off a usb drive that has yocto on it I am trying to connect to the CRB from my host in order to debug using TCF agent. Through eclipse I am entering the IP address of the target, and attempting to debug from the debug configurations menu. Using a simple helloworld as an example, the file is actually transferred to the target CRB, but the debugging fails. Eclipse gives me a connection timing out error (not allowing me to debug). Is there a link that describes how to connect to a physical target using eclipse and the ADT? Is there anything that must be done on the target side first before attempting to debug? I only enter the IP address of the target under debug configurations, I don't setup anything on the target side, maybe this is the problem? I followed the same procedure as connecting to the QEMU (which works) as I did with the physical hardware. I can't find anything online about a connection time out either.
> 
> Thanks
> _______________________________________________
> yocto mailing list
> yocto at yoctoproject.org
> https://lists.yoctoproject.org/listinfo/yocto