[yocto] Connecting to target using eclipse/ADT

[Zhang, Jessica]

So do you have access to your target at all? Can you verify that the tcf-agent is up running on the target device?

-----Original Message-----
From: yocto-bounces at yoctoproject.org [mailto:yocto-bounces at yoctoproject.org] On Behalf Of Emir Elkholy
Sent: Tuesday, May 22, 2012 11:58 AM
To: yocto at yoctoproject.org
Subject: [yocto] Connecting to target using eclipse/ADT

When connecting to my CRB that is running off a usb drive that has yocto on it I am trying to connect to the CRB from my host in order to debug using TCF agent. Through eclipse I am entering the IP address of the target, and attempting to debug from the debug configurations menu. Using a simple helloworld as an example, the file is actually transferred to the target CRB, but the debugging fails. Eclipse gives me a connection timing out error (not allowing me to debug). Is there a link that describes how to connect to a physical target using eclipse and the ADT? Is there anything that must be done on the target side first before attempting to debug? I only enter the IP address of the target under debug configurations, I don't setup anything on the target side, maybe this is the problem? I followed the same procedure as connecting to the QEMU (which works) as I did with the physical hardware. I can't find anything online about a connection time out either.

Thanks
_______________________________________________
yocto mailing list
yocto at yoctoproject.org
https://lists.yoctoproject.org/listinfo/yocto