[meta-freescale] Getting Started With A New freescale / NXP LS1021-TWR

[Zhenhua Luo]

Hello Thomas, 

In u-boot environment, you don't set the "consoledev" variable. Please set this variable and try again. 


Best Regards,

Zhenhua

> -----Original Message-----
> From: meta-freescale-bounces at yoctoproject.org [mailto:meta-freescale-
> bounces at yoctoproject.org] On Behalf Of Thomas A. F. Thorne MEng AUS MIET
> Sent: Thursday, August 25, 2016 8:53 PM
> To: meta-freescale at yoctoproject.org
> Subject: [meta-freescale] Getting Started With A New freescale / NXP LS1021-
> TWR
> 
> Good afternoon,
> 
> Has anyone got a kernel from a recent release to come up on a recently
> produced LS1021TWR board?  I have been struggling to get an LS1021-TWR
> board booting from images that I have generated using the community
> freescale.  I have also tried to use the freescale SDK for the board without
> much success, so it seems likely there is some common fault, probably with my
> configuration, if not the hardware or pre-loaded binaries.
> 
> I ask specifically about it being a recently produced board as it sounds as if the
> CPU has been updated and may not work as it did before.  This is based off of
> some discussions I had with a distributor over the past couple of weeks.
> Initially I thought this was something causing an issue with just the LS1021-IOT
> boards and their SDKs but it sounds like both Internet Of Things and ToWeR
> designs are effected.
> 
> I had made a post about my difficulties on the NXP Community site, but not
> received any comments on it yet.
> https://community.nxp.com/thread/432937  The post includes a summary of
> my issue, the environment variables that I have set and the serial output from
> the board.  I can provide further details through this mailing list too, but I did
> not want to generate a huge email full of what might be irrelevant data.  The
> short summary is that I get as far as the "Starting kernel ..." message and then
> see no further output from the board.  This is true when trying to boot from
> the SD card or over NFS.
> 
> If anyone can provide any suggestions or pointers I would be very grateful to
> hear them.
> 
> Regards, Thomas
> 
> --
> Thomas Thorne  Software Engineer  Net2Edge Limited
> Tel: +44 3450 130 030
> Email: Thomas.Thorne at Net2Edge.com
> Web: http://www.Net2Edge.com/
> 
> Net2Edge Limited is a company registered in England & Wales (Company No.
> 2438435, VAT No. GB 537553821) Passfield Oak, Liphook, Hampshire, GU30 7RL.
> This email transmission is confidential and intended solely for the person or
> organisation to whom it is addressed. If you are not the intended recipient, you
> must not copy, distribute or disseminate the information, or take any action in
> reliance of it. Any views expressed in this message are those of the individual
> sender, except where the sender specifically states them to be the views of
> any organisation or employer. If you have received this message in error, do
> not open any attachment but please notify the sender (above) and delete this
> message from your system. Please rely on your own virus check. Although all
> outbound mail is checked for viruses, no responsibility is taken by the sender
> for any damage rising out of any bug or virus infection.
>