[yocto] Creating my own bsp

[Larry Brown]

I've come across references to "yocto-bsp" script that should help build a
bsp.  I'm starting from scratch with an arm 7M and trying to use the
raspberrypi bsp as a reference.  There is so much complexity I'm not sure
where to start.

After setting up the files for the Linux kernel I'm using already on the
board and the config, it first complained about TUNE_ARCH not being
present.  This is not present in the meta-raspberrypi content but based on
something I came across this just wants arm.  Then it complains
TUNE_PKGARCH is not set.  I don't know what this is looking for and I'm not
getting effective hits searching for it.  I'm guessing there are going to
be a lot more after these two complaints.  It would be nice to read what
went into a simple bsp that worked under for an arm board.

PS I'm using the warrior release as it worked for bringing up the raspberry
pi.

Any help would be greatly appreciated.

-- 
Larry Brown
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.yoctoproject.org/pipermail/yocto/attachments/20190621/e49efc11/attachment.html>