[yocto] dhcp eth0 network
peter@gmail.com
balazovic.peter at gmail.com
Fri May 12 12:34:31 PDT 2017
I build on i.mx (NXP) machine, I want to get configured as dhcp (no
static)...
------ Original Message ------
From: "Trevor Woerner" <twoerner at gmail.com>
To: "Peter Balazovic" <balazovic.peter at gmail.com>
Cc: "Yocto list discussion" <yocto at yoctoproject.org>
Sent: 5/12/2017 9:32:17 PM
Subject: Re: [yocto] dhcp eth0 network
>Hi Peter,
>
>For what MACHINE are you building? What's your target hardware? Can
>you summarize the steps you took to build your image?
>
>What do you want eth0 to do? dhcp or static ip?
>
>Best regards,
> Trevor
>
>
>On Fri, May 12, 2017 at 12:01 PM, Peter Balazovic
><balazovic.peter at gmail.com> wrote:
>> Dears,
>>
>> I got Yocto image and unfortunatelly network is not somehow enabled &
>> proprely configured. After "ifconfig" no eth0 configured.
>>
>>
>>> ifconfig
>> lo Link encap:Local Loopback
>> inet addr:127.0.0.1 Mask:255.0.0.0
>> ....
>>
>>
>>
>>> /etc/network
>>> ls
>> if-down.d if-post-down.d if-pre-up.d if-up.d
>>
>>
>> How should I setup "eth0" to get network working properly?
>>
>> Thanks.
>>
>>
>>
>> --
>> _______________________________________________
>> yocto mailing list
>> yocto at yoctoproject.org
>> https://lists.yoctoproject.org/listinfo/yocto
>>
More information about the yocto
mailing list