[yocto] [meta-rockchip][PATCH] README: remove irrelevant information

[Khem Raj]

On Sat, May 6, 2017 at 7:41 AM, Romain Perier <romain.perier at gmail.com> wrote:
> Hello,
>
> Even if I agree with the reason of why you want to remove this section. I
> think , it might be a good point to keep a note about this in the README.
> Just explain that this is not up to the bsp layer to do this, but to the
> distro (a short sentence).
>
> What do you think ?

You can put something like distro guidelines. Although I would refrain

> Romain
>
>
> 2017-04-30 4:23 GMT+02:00 Trevor Woerner <twoerner at gmail.com>:
>>
>> As of openembedded-core commit 2b3ae58f5eaecc8474761c543ff5347aa0e3c4c8
>> hardfp
>> is enabled by default.
>>
>> Signed-off-by: Trevor Woerner <twoerner at gmail.com>
>> ---
>>  README | 16 ----------------
>>  1 file changed, 16 deletions(-)
>>
>> diff --git a/README b/README
>> index b2e89f3..7f4a499 100644
>> --- a/README
>> +++ b/README
>> @@ -49,7 +49,6 @@ Table of Contents
>>    I. Configure yocto/oe environment
>>   II. Building a second level bootloader based on kexec
>>  III. Booting your device
>> - IV. Performance
>>
>>  I. Configure yocto/oe environment
>>  ========================================
>> @@ -127,18 +126,3 @@ linux-next from tftp='tftp://192.168.0.5/zImage
>> dtb=tftp://192.168.0.5/<MACHINE>
>>  Then, plug your SDCARD into your Rockchip device and power on the board.
>> If
>>  everything worked fine, Petitboot should be started automatically and
>> list all
>>  entries found in the configuration file.
>> -
>> -IV. Performance
>> -===============
>> -
>> -By default a BSP layer should not be tuning a build, this is a
>> DISTRO-level
>> -decision. As such the default machine settings are meant to be the lowest
>> -common denominator in order to maximize generality. If you are interested
>> in
>> -tweaking your build to maximize performance you can either use a DISTRO
>> that
>> -has these same goals, or you can add settings in your configuration files
>> -(e.g. local.conf) as follows:
>> -
>> -       for rk3288:
>> -               DEFAULTTUNE = "cortexa17hf-neon-vfpv4"
>> -       for rk3066:
>> -               DEFAULTTUNE = "cortexa9-neon"
>> --
>> 2.12.0.rc1.48.g076c053
>>
>> --
>> _______________________________________________
>> yocto mailing list
>> yocto at yoctoproject.org
>> https://lists.yoctoproject.org/listinfo/yocto
>
>
>
> --
> _______________________________________________
> yocto mailing list
> yocto at yoctoproject.org
> https://lists.yoctoproject.org/listinfo/yocto
>