[yocto] beagleboard core-image-sato boots to serial port poky 1.3_M2

[Paul Eggleton]

On Thursday 26 July 2012 08:52:55 Edward Vidal wrote:
> I added the line below to uEnv.txt based on Yi Zhao message.
> bootcmd="mmc rescan 0; fatload mmc 0:1 0x80300000 uImage; bootm 0x80300000"
> Now uEnv.txt is the following
> mpurate=auto
> 
> bootcmd="mmc rescan 0; fatload mmc 0:1 0x80300000 uImage; bootm 0x80300000"
> dvimode="hd720 omapfb.vram=0:8M,1:4M,2:4M"
> vram=16M
> optargs="consoleblank=0"
> console="tty0 console=ttyO2,115200n8"
> The system boots and with the network setup i can ssh into the beagleboard.
> checking dmesg I see the following.
> 
> Unable to get DVI reset GPIO
>  omap-mcbsp.2: alias fck already exists
>  omap-mcbsp.3: alias fck already exists
> OMAP DMA hardware revision 5.0
> 
> I tried id:3:initdefault still no display on beagleboard display.
> Thanks any help will be appreciated :

Edward, 

Unfortunately I can't help much with your problem at this point, sorry about 
that - but could I ask you to keep this discussion as part of a single thread? 
It would make the discussion easier to follow.

Thanks,
Paul

-- 

Paul Eggleton
Intel Open Source Technology Centre