[yocto] Color ghosting on BeagleBoard xM rev C
Koen Kooi
koen at dominion.thruhere.net
Fri Jul 15 12:12:35 PDT 2011
Op 15 jul 2011, om 20:33 heeft Darren Hart het volgende geschreven:
> Jason, Koen,
>
> Does anything spring to mind as an obvious fix for this? Perhaps some
> kernel parameter initialization string for the graphics hardware?
I've never seen it in angstrom, so you'd have to see what meta-yocto is doing different. In other news, for beagleboard please use the meta-ti layer for that, it's the offcial upstream for beagle and is known to work.
>
> --
> Darren
>
> On 07/15/2011 08:30 AM, Jeff Mitchell wrote:
>> Darren Hart suggested I send this to the list...
>>
>> Attached is a picture of my screen running Terminal. This is on a
>> BeagleBoard xM rev C connected via its HDMI out to a DVI adapter and
>> then into a Dell UltraSharp monitor. Angstrom doesn't display these
>> problems, so the setup should be fine.
>>
>> I'm not quite sure what is causing this. The resolution is also fairly
>> low, and I haven't had any success using boot parameters (either the
>> older video=omapfb:mode variant or the newer DSS2 omapfb.mode variant).
>>
>> Thanks,
>> Jeff
>>
>>
>>
>> _______________________________________________
>> yocto mailing list
>> yocto at yoctoproject.org
>> https://lists.yoctoproject.org/listinfo/yocto
>
> --
> Darren Hart
> Intel Open Source Technology Center
> Yocto Project - Linux Kernel
More information about the yocto
mailing list