[meta-xilinx] qemuzynq fails to boot

[Nathan Rossi]

> -----Original Message-----
> From: meta-xilinx-bounces at yoctoproject.org [mailto:meta-xilinx-
> bounces at yoctoproject.org] On Behalf Of Simon Vincent
> Sent: Thursday, September 11, 2014 12:40 AM
> To: meta-xilinx at yoctoproject.org
> Subject: [meta-xilinx] qemuzynq fails to boot
> 
> I have built a linux image for qemu-zynq via setting my yocto machine to
> qemuzynq and doing a bitbake core-image-minimal
> 
> I then try and run the image on qemu via the following command:
> runqemu qemuzynq nographic
> 
> I then find it starts to boot and locks up at the end. I get the
> following error messages:
> Stopping Bootlog daemon: bootlogd.
> INIT: Id "PS0" respawning too fast: disabled for 5 minutes
> INIT: Id "1" respawning too fast: disabled for 5 minutes
> INIT: no more processes left in this runlevel
> 
> The full boot output can be found at:
> http://pastebin.com/MvEHN9Tk

Hi,

I have been away for a few weeks, so I have only just had a chance to look at this. Is this still an issue? As I am unable to reproduce this with meta-xilinx + oe-core master.

If it is, could you provide your build setup (the message at the top of a bitbake run is sufficient).

Regards,
Nathan