[meta-xilinx] U-boot SPL and NAND support for the zynq

[Mike Looijmans]

We've discussed u-boot SPL on this board before, so I expect my intended 
audience to be here.

Has anyone here used Zynq NAND support in u-boot? And SPL?


The status a few months ago appeared to be that NAND would work, but SPL did 
not compile because of missing source files. I could boot from SD and then 
address the NAND device though, which was enough for that day as I just wanted 
to verify the NAND chip was wired and soldered correctly.

I tried upgrading u-boot to the status quo today, and to my surprise, u-boot 
fails to build (linker error) when I enable CONFIG_NAND_ZYNQ:

|   LD      spl/u-boot-spl
| arm-oe-linux-gnueabi-ld.bfd:u-boot-spl.lds:1: ignoring invalid character `#' 
in expression
| arm-oe-linux-gnueabi-ld.bfd:u-boot-spl.lds:1: syntax error
| make[1]: *** [spl/u-boot-spl] Error 1




Met vriendelijke groet / kind regards,

Mike Looijmans

TOPIC Embedded Systems
Eindhovenseweg 32-C, NL-5683 KH Best
Postbus 440, NL-5680 AK Best
Telefoon: (+31) (0) 499 33 69 79
Telefax:  (+31) (0) 499 33 69 70
E-mail: mike.looijmans at topic.nl
Website: www.topic.nl

Please consider the environment before printing this e-mail

Bezoek ons op 9 en 10 september tijdens Technology for Health Den Bosch (stand 53)
http://www.technologyforhealth.nl