[meta-freescale] t4240 offloading applications
zhenhua.luo at freescale.com
zhenhua.luo at freescale.com
Wed Jun 25 03:19:24 PDT 2014
Please use uImge-t4240qds-usdpaa.dtb instead of uImage-t4240qds.dtb.
Best Regards,
Zhenhua
From: meta-freescale-bounces at yoctoproject.org [mailto:meta-freescale-bounces at yoctoproject.org] On Behalf Of hari prasad
Sent: Wednesday, June 25, 2014 1:26 AM
To: Luo Zhenhua-B19537
Cc: meta-freescale at yoctoproject.org
Subject: Re: [meta-freescale] t4240 offloading applications
uboot environment variables:
U-Boot 2013.01 (May 25 2014 - 14:54:05)
CPU0: T4240E, Version: 1.0, (0x82480010)
Core: E6500, Version: 1.0, (0x80400010)
Clock Configuration:
CPU0:1666.667 MHz, CPU1:1666.667 MHz, CPU2:1666.667 MHz, CPU3:1666.667 MHz,
CPU4:1666.667 MHz, CPU5:1666.667 MHz, CPU6:1666.667 MHz, CPU7:1666.667 MHz,
CPU8:1666.667 MHz, CPU9:1666.667 MHz, CPU10:1666.667 MHz, CPU11:1666.667 MHz,
CCB:600 MHz,
DDR:400 MHz (800 MT/s data rate) (Asynchronous), IFC:150 MHz
FMAN1: 466.667 MHz
FMAN2: 466.667 MHz
QMAN: 300 MHz
PME: 300 MHz
L1: D-cache 32 kB enabled
I-cache 32 kB enabled
Reset Configuration Word (RCW):
00000000: 120c0019 0c10190e 00000000 00000000
00000010: 04023033 00558c00 1c020000 19000000
00000020: 00000000 ee0000ee 00000000 000307fc
00000030: 00000000 00000000 00000000 00000010
Board: T4240QDS, Sys ID: 0x1e, Sys Ver: 0x24, vBank: 4
FPGA: v3 (T4240QDS_2012_1113_1114), build 438 on Tue Nov 13 17:14:23 2012
SERDES Reference Clocks: SERDES1=125MHz SERDES2=125MHz SERDES3=100MHz SERDES4=100MHz
I2C: ready
SPI: ready
DRAM: Initializing....using SPD
Detected UDIMM 9JSF25672AZ-2G1K1
Detected UDIMM 9JSF25672AZ-2G1K1
Detected UDIMM 9JSF25672AZ-2G1K1
4 GiB left unmapped
DDR: 6 GiB (DDR3, 64-bit, CL=6, ECC on)
DDR Controller Interleaving Mode: 3-way 4KB
Flash: 128 MiB
L2: 2048 KB enabled
enable l2 for cluster 1 fec60000
enable l2 for cluster 2 feca0000
Corenet Platform Cache: 1536 KB enabled
Using SERDES1 Protocol: 1 (0x1)
Using SERDES2 Protocol: 1 (0x1)
Using SERDES3 Protocol: 6 (0x6)
Using SERDES4 Protocol: 6 (0x6)
SRIO1: enabled
SRIO2: enabled
NAND: 512 MiB
MMC: FSL_SDHC: 0
EEPROM: NXID v1
PCIe1: Root Complex, no link, regs @ 0xfe240000
PCIe1: Bus 00 - 00
PCIe2: disabled
PCIe3: Root Complex, no link, regs @ 0xfe260000
PCIe3: Bus 01 - 01
PCIe4: disabled
In: serial
Out: serial
Err: serial
Net: Fman1: Uploading microcode version 106.4.9
Fman2: Uploading microcode version 106.4.9
FM1 at DTSEC5 [PRIME], FM1 at TGEC1, FM2 at DTSEC5
Hit any key to stop autoboot: 0
=>
=> setenv ethact FM1 at TGEC1
=> setenv ethprime FM1 at TGEC1
=> print
baudrate=115200
bdev=sda3
bootargs=root=/dev/mmcblk0p1 rw rootdelay=5 console=ttyS0,115200 usdpaa_mem=256M bportals=s0-1 qportals=s0-1
bootcmd=setenv bootargs root=/dev/mmcblk0p1 rw rootdelay=2 console=$consoledev,$baudrate;
mmcinfo;ext2load mmc 0:1 $loadaddr $bootfile;ext2load mmc 0:1 $fdtaddr $fdtfile; bootm $loadaddr - $fdtaddr
bootdelay=3
bootfile=uImage
consoledev=ttyS0
eth10addr=00:04:9F:02:7A:39
eth11addr=00:04:9F:02:7A:3A
eth12addr=00:04:9F:02:7A:3B
eth13addr=00:04:9F:02:7A:3C
eth14addr=00:04:9F:02:7A:3D
eth15addr=00:04:9F:02:7A:3E
eth1addr=00:04:9F:02:7A:30
eth2addr=00:04:9F:02:7A:31
eth3addr=00:04:9F:02:7A:32
eth4addr=00:04:9F:02:7A:33
eth5addr=00:04:9F:02:7A:34
eth6addr=00:04:9F:02:7A:35
eth7addr=00:04:9F:02:7A:36
eth8addr=00:04:9F:02:7A:37
eth9addr=00:04:9F:02:7A:38
ethact=FM1 at TGEC1
ethaddr=00:04:9F:02:7A:2F
ethprime=FM1 at TGEC1
fdtaddr=0x17200000
fdtfile=uImage-t4240qds.dtb
fileaddr=1000000
filesize=46573C
fman_ucode=0xeff40000
gatewayip=192.168.1.1
hwconfig=fsl_ddr:ctlr_intlv=3way_4KB,bank_intlv=auto;fsl_fm1_xaui_phy:xfi;fsl_fm2_xaui_phy:xfi
ipaddr=10.116.65.141
loadaddr=0x10000000
netdev=eth0
netmask=255.255.255.0
nfsboot=setenv bootargs root=/dev/nfs rw nfsroot=$serverip:$rootpath ip=$ipaddr:$serverip:$gatewayip:$netmask:$hostname:$netdev:off console=$consoledev,$baudrate $othbootargs;tftp $loadaddr $bootfile;tftp $fdtaddr $fdtfile;bootm $loadaddr - $fdtaddr
ramboot=setenv bootargs root=/dev/ram rw console=$consoledev,$baudrate $othbootargs;tftp $ramdiskaddr $ramdiskfile;tftp $loadaddr $bootfile;tftp $fdtaddr $fdtfile;bootm $loadaddr $ramdiskaddr $fdtaddr
ramdiskaddr=2000000
ramdiskfile=t4240qds/ramdisk.uboot
rcw=t4240rcw
rcw_spi=mw.w ffdf0060 2201;qixis_reset altbank
rcwemmc=mw.w ffdf0060 2000
rootpath=/opt/nfsroot
sataboot=setenv bootargs root=/dev/sda1 rootdelay=5 rw console=$consoledev,$baudrate $othbootargs;bootm e8020000 - e8800000
sdboot=setenv bootargs root=/dev/mmcblk0p1 rw rootdelay=5 console=ttyS0,115200; ext2load mmc 0:1 $loadaddr $bootfile; ext2load mmc 0:1 $fdtaddr $fdtfilel bootm $loadaddr - $fdtaddr
serverip=10.116.65.150
stderr=serial
stdin=serial
stdout=serial
tftpflash=tftpboot $loadaddr $uboot && protect off $ubootaddr +$filesize && erase $ubootaddr +$filesize && cp.b $loadaddr $ubootaddr $filesize && protect on $ubootaddr +$filesize && cmp.b $loadaddr $ubootaddr $filesize
tftprcw=tftpboot $loadaddr $rcw && mmcinfo && mmc write 1000000 8 1
uboot="u-boot.bin"
ubootaddr=0xeff80000
regards,
Hari Prasad S R
7418234575
On Tue, Jun 24, 2014 at 8:37 AM, zhenhua.luo at freescale.com<mailto:zhenhua.luo at freescale.com> <zhenhua.luo at freescale.com<mailto:zhenhua.luo at freescale.com>> wrote:
Do you use the usdpaa dtb(t4240qds-usdpaa.dtb)? Please provide more details, e.g. u-boot setting, bootargs, etc.
Best Regards,
Zhenhua
From: meta-freescale-bounces at yoctoproject.org<mailto:meta-freescale-bounces at yoctoproject.org> [mailto:meta-freescale-bounces at yoctoproject.org<mailto:meta-freescale-bounces at yoctoproject.org>] On Behalf Of hari prasad
Sent: Monday, June 23, 2014 5:59 PM
To: meta-freescale at yoctoproject.org<mailto:meta-freescale at yoctoproject.org>
Subject: [meta-freescale] t4240 offloading applications
HI,
I am trying to run usdpaa offloading applications in t4240qds but drivers dpa_stats and dpa_classifier are not present in /dev/ . How can I get these applications to work
regards,
Hari Prasad S R
7418234575
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.yoctoproject.org/pipermail/meta-freescale/attachments/20140625/5f9638aa/attachment-0001.html>
More information about the meta-freescale
mailing list