[meta-freescale] [meta-fsl-arm][PATCH 0/4] Add support for Phytec Vybrid boards

[Daiane.Angolini at freescale.com]

> -----Original Message-----
> From: meta-freescale-bounces at yoctoproject.org [mailto:meta-freescale-
> bounces at yoctoproject.org] On Behalf Of Anthony Felice
> Sent: Thursday, February 27, 2014 3:48 PM
> To: meta-freescale at yoctoproject.org
> Subject: [meta-freescale] [meta-fsl-arm][PATCH 0/4] Add support for Phytec
> Vybrid boards
> 
> This series adds support for the Phytec Cosmic Vybrid (pcl052) and Phytec
> phyCORE Vybrid (pcm052) machines.
> 
> The first patch adds a modified u-boot 2011.12 with board support enabled
> for these two machines, as the pcl052 and pcm052 are not supported in
> mainline u-boot.
> 
> The second patch reworks the linux-timesys recipe to use the twr-vf65gs10
> machine name for sources. This is in preparation for the Phytec board
> support addition, as the Phytec machine names will also be used for
> sources.
> 
> The third patch adds the machine definition for the pcl052 board.
> 
> The fourth patch adds the machine definition for the pcm052 board.
> 


Very nice, Anthony!

Thanks a lot for sending those new board support files ;-)

I have reviewed and nothing special. Only double check the copyright and the COMPATIBLE_MACHINE,
but if you think the patches are OK, I´m fine 

(i´m sorry I have reviewed the patches in the wrong order... when I realized it was too late)

Daiane