[meta-freescale] Patch submission to Freescale kernel
Gary Bisson
bisson.gary at gmail.com
Mon Dec 1 20:18:20 PST 2014
Hi,
I was wondering what was the procedure to submit a patch to the
Freescale maintained kernel:
http://git.freescale.com/git/cgit.cgi/imx/linux-2.6-imx.git/
I've just made a patch that fixes the display issue for rev T1.0 of the
SoC which has been previously reported:
https://lists.yoctoproject.org/pipermail/meta-freescale/2014-May/008553.html
"mxc_sdc_fb fb.27: timeout when waiting for flip irq"
Then, I'd like to send that patch over to the fslc and mainline kernels
as they seem to have the issue by checking their source code.
Regarding the mainline kernel, I can't seem to get the HDMI (on
nitrogen6x) to work at all no matter which revision/board I use. Looking
into the source code I've seen the evolution of the
drivers/staging/imx-drm driver which tends to say that HDMI is
supported. If so, would anyone have some insights on which command line
to pass the kernel in order to get the mainline kernel to recognize the
HDMI display properly. So far the init seems to be fine but fb0 sysfs
modes is just rubbish.
[ 1.863506] imx-drm display-subsystem: bound imx-ipuv3-crtc.0 (ops
ipu_crtc_ops)
[ 1.863719] imx-drm display-subsystem: bound imx-ipuv3-crtc.1 (ops
ipu_crtc_ops)
[ 1.863955] imx-drm display-subsystem: bound imx-ipuv3-crtc.4 (ops
ipu_crtc_ops)
[ 1.864168] imx-drm display-subsystem: bound imx-ipuv3-crtc.5 (ops
ipu_crtc_ops)
[ 1.867758] imx-hdmi 120000.hdmi: Detected HDMI controller
0x13:0xa:0xa0:0xc1
[ 1.868066] imx-drm display-subsystem: bound 120000.hdmi (ops hdmi_ops)
[ 1.868537] imx-drm display-subsystem: bound
2000000.aips-bus:ldb at 020e0008 (ops imx_ldb_ops)
Thanks,
Gary
More information about the meta-freescale
mailing list