[meta-freescale] [meta-fsl-arm-extra][PATCH 1/2] u-boot-imx: update Congatec qmx6 support to bsp 4.0

[SARTRE Leo]

> If you have your boot pins (or fuses) correctly setup and flash it to
> the correct offset, it should just boot, no?
> 

When I try to flash a mainline U-boot (that works when I write it in SD card) 
into the SPI NOR, the board doesn't boot.
The binary that I flash is a non-padded Uboot and I place it at the beggining 
of the SPI NOR.
It seems that the same issue occurs with the sabrelite board (see 
https://wiki.linaro.org/Boards/MX6QSabreLite).

> I don't understand why you say that mainline U-boot cannot boot from
> SPI NOR, but the old U-boot can.

Maybe some bits of code maintained by Freescale were not pushed to the 
mainline of U-boot.

--
Léo
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.yoctoproject.org/pipermail/meta-freescale/attachments/20130618/5e7fbe04/attachment.html>