[meta-freescale] Booting Yocto on i.MX35
Daiane Angolini
daiane.angolini at freescale.com
Thu Jun 13 12:19:54 PDT 2013
On 06/13/2013 04:10 PM, Gary Thomas wrote:
> I have an i.MX35 PDK that I'd like to run Yocto on. I've built
> an SD card image using TARGET=imx35pdk. All went well (past the
> small problem of the initial clone of the linux-mainline git
> tree - timed out and I downloaded it by hand). However, when
> I set the jumpers to boot from SD card, I get continuous errors:
> ++NAND: RCSR=b000900
> Searching for BBT table in the flash ...
> .
> Found version 1 Bbt0 at block 8191 (0x7ffc0000)
> Total bad blocks: 0
> ... Read from 0x07ec0000-0x07f00000 at 0x00080000: ..
> ... Read from 0x07eb3000-0x07eb4000 at 0x000bf000: .
> PMIC ID: 0x00000010 [Rev: 1.0]
> Board version V2.0
> Launching POST
> Fail, CMD13
> Fail, CMD13
>
> I'll try another SD card when I can get access to one (I'm away
> from my office now), but thought I would ask if I've missed something?
> Can someone tell me _definitively_ how to set the jumpers for this mode
> since the quick start guide and hardware guide don't match??
I don't like to rely on my memory. But I remember imx35pdk had a
"different" way to set up the switch for internal boot/nand boot/atk
boot/whatever.
But, from your log, you're booting from NAND (no need to blame your sdcard)
Try this one:
https://community.freescale.com/docs/DOC-1307
>
> Thanks for any pointers.
>
> n.b. I'm also interested if anyone out there has had success with
> this setup :-)
--
Daiane
More information about the meta-freescale
mailing list