[meta-freescale] fsl.image-test boot problem
Mattias Sahlén
mattias.sahlen at vinnter.se
Mon Feb 4 08:28:20 PST 2013
Ok, thanks for the information. I will look into it at my end as well.
/Mattias
________________________________________
Från: Fabio Estevam [festevam at gmail.com]
Skickat: den 4 februari 2013 16:15
Till: Mattias Sahlén
Kopia: meta-freescale at yoctoproject.org
Ämne: Re: [meta-freescale] fsl.image-test boot problem
Hi Mattias,
On Mon, Feb 4, 2013 at 12:32 PM, Mattias Sahlén
<mattias.sahlen at vinnter.se> wrote:
> Hi.
> I followed this guide:
> https://community.freescale.com/docs/DOC-93844 and built the fsl-image-test
> for the SABRE SD board.
>
> I dd it to an SD card like so:
> sudo dd if=fsl-image-test-imx6qsabresd.sdcard of=/dev/mmcblk0
>
> I insert the SD card in to the card reader and boot from it. It starts to
> boot and loads the kernel, then it restart...
> It keeps doing this forever. Has anyone experienced this? Has anyone built
> the image recently?
I saw this problem too and the same SD card image that boots fine on a
mx6qsabresd revB fails on a revC (board gets resetted when userspace
starts running).
Currently U-boot 2013.01 is not passing the correct board revision to
the kernel.
I will investigate this issue when I get a chance.
Regards,
Fabio Estevam
More information about the meta-freescale
mailing list