[meta-freescale] MX28 Enable Watchdog reset

[Fabio Estevam]

On Thu, Aug 15, 2013 at 2:00 AM, Mårten Wikman <marten.wikman at novia.fi> wrote:

> Just after I sent this question to the mailinglist I found out it's possible
> to enable watchdog  just by writing something into /dev/watchdog0. However I
> don't know yet how to enable watchdog very early in the boot process, I have
> seen some posts on freescale community that says how to do it from u-boot,
> that could be one way to do it.

Yes, just tried 'echo 0 > /dev/watchdog' and then after about 20
seconds the watchdog resets the board.