[yocto] Managing multiple builds
Mike Looijmans
mike.looijmans at topic.nl
Wed Feb 13 23:18:09 PST 2019
Two products sounds like two machines. Just create a machine.conf for each
product (even if they use similar hardware), then you don't need overrides
elsewhere.
OE/Yocto is smart enough to figure out what needs to be (re)built. Some OE
projects build the same image(s) for over 40 machines (and counting)...
On 14-02-19 01:34, Timothy Froehlich wrote:
>
> Hi, I've been struggling a bit with this question. I want to use Yocto to
> build two+ products with separate dev/prod images for each (dev including
> debug-tweaks, etc.). I've ruled out separate image recipes because my dev
> builds need ENABLE_UART on my RaspberryPi and that needs to be set at the conf
> level (I've got it set conditionally in my base dist conf). Multiconfig looked
> promising, but I'm not happy about how long the parsing takes to start a
> build. "--postread" looked nice, but I've barely seen it mentioned so I'm
> worried that it's not well supported.
>
> Basically, what do most people do for controlling their builds?
> Tim Froehlich
> Embedded Linux Engineer
> tfroehlich at archsys.io <mailto:tfroehlich at archsys.io>
> 215-218-8955
>
More information about the yocto
mailing list