[yocto] Wireshark but no Tshark?
michael.calve at vectare.com
Mon Jun 12 10:19:34 PDT 2017
I was able to create a username and password, and use this as credentials
for SSH. However, I can't run some of the commands that I can when using
picocom, and thus operating as root.
On Mon, Jun 12, 2017 at 10:34 AM, Michael Calve <michael.calve at vectare.com>
> Okay thank you very much for the clarification.
> Is there a set password for the root username? I'm attempting to send
> files across and run scripts abord the joule from my host system!
> On Mon, Jun 12, 2017 at 3:50 AM, Jussi Kukkonen <jussi.kukkonen at intel.com>
>> On 7 June 2017 at 20:59, Michael Calve <michael.calve at vectare.com> wrote:
>>> Hi, I've seen that Wireshark is portable to Yocto, however Tshark is
>>> not? Is there other/better software for reading pcaps and getting field
>> tshark is part of wireshark: it should be built by the wireshark recipe
>> in meta-networking.
>> If you want a smaller footprint tool, try tcpdump (also in
>> meta-networking). It's not as featureful as tshark but uses the same
>> sniffing library and wireshark can display tcpdump results just fine.
-------------- next part --------------
An HTML attachment was scrubbed...
More information about the yocto