[yocto] Problem Booting Yocto 1.7.3

[Clay D. Montgomery]

Hello,

    I'm trying to update from Yocto (Dizzy) 1.7.2 to 1.7.3 for a 
Wandboard Quad, but it hangs at the point where u-boot is trying to 
start the kernel. I'm guessing maybe this is because my image has u-boot 
2014 and I need u-boot 2015?  I have read that u-boot 2015 is required 
for Yocto 1.8 (Fido), because it has a newer kernel (3.14). But, my 
Yocto 1.7.3 build is still the 3.10.17 kernel.  Is it possible Bitbake 
built this image with u-boot and kernel versions that are not 
compatible, or am I missing the real issue?

   I am pasting my boot log below, up to the point where it hangs. I 
would really appreciate any help.

Thanks, Clay Montgomery


U-Boot 2014.10+fslc+g5fd0b60 (Nov 14 2015 - 17:25:56)

CPU:   Freescale i.MX6Q rev1.2 at 792 MHz
Reset cause: POR
Board: Wandboard
I2C:   ready
DRAM:  2 GiB
MMC:   FSL_SDHC: 0, FSL_SDHC: 1
auto-detected panel HDMI
Display: HDMI (1024x768)
In:    serial
Out:   serial
Err:   serial
Net:   FEC [PRIME]
Hit any key to stop autoboot:  0
switch to partitions #0, OK
mmc0 is current device
reading boot.scr
** Unable to read file boot.scr **
reading zImage
5442368 bytes read in 359 ms (14.5 MiB/s)
Booting from mmc ...
reading imx6q-wandboard.dtb
43370 bytes read in 21 ms (2 MiB/s)
Kernel image @ 0x12000000 [ 0x000000 - 0x530b40 ]
## Flattened Device Tree blob at 18000000
    Booting using the fdt blob at 0x18000000
    Using Device Tree in place at 18000000, end 1800d969

Starting kernel ...