[yocto] Microcontroller Cross Compiler

[João Henrique Ferreira de Freitas]

Hi,

I have the same requirement.

I will try it. But in my case I need to use this 
https://launchpad.net/gcc-arm-embedded.

There are some way to yocto creates the gcc-arm-embedded SDK? Instead of 
use the gcc-arm-embedded packages. Is it feasibly?

Thanks.


On 19/12/2014 11:21, Andrea Adami wrote:
> On Thu, Dec 18, 2014 at 8:09 PM, Darcy Watkins
> <dwatkins at sierrawireless.com> wrote:
>> Hello,
>>
>> In my target system I have a microcontroller (MCU) that handles some I/O, power supplies and system boot up to the point of taking the main CPU out of reset.  At present, we build the MCU firmware from source and then the binary file is packaged to be used as payload with an MCU firmware update utility.
>>
>> Now my main question...  does anyone have suggestions (or is there a 'yocto' way) to build such a cross compiler for the MCU so that it can be invoked to build MCU firmware from source as part of the bitbake build for the Linux target's image.  The idea would be to build MCU firmware image from source using the MCU cross compiler, but obviously to build drivers and utilities that run on the main CPU using the normal cross-compiler toolchains built under yocto.  Then I could package the payload firmware image along with utilities all as part of the same RPM package.
>>
>> The MCU cross compiler we use was originally generated using crosstool-ng, and is essentially a gcc cross compiler for 'bare metal' MCU target.
>>
>> Does anyone who has gone down this road have suggestions?
>>
>> Thanks in advance!
>>
>>
>> Regards,
>>
>> Darcy
>>
>> Darcy Watkins ::  Staff Engineer, Firmware
>>
>> SIERRA WIRELESS
>> Direct  +1 604 233 7989   ::  Fax  +1 604 231 1109  ::  Main  +1 604 231 1100
>> 13811 Wireless Way  :: Richmond, BC Canada V6V 3A4
>> [P2]
>> dwatkins at sierrawireless.com :: www.sierrawireless.com :: www.inmotiontechnology.com
>>
>> --
>> _______________________________________________
>> yocto mailing list
>> yocto at yoctoproject.org
>> https://lists.yoctoproject.org/listinfo/yocto
> Hi Darcy,
>
> if I understand correctly you use the standard toolchain for the
> target image and a custom $CC to build one custom binary.
>
> We use klcc for a couple of klibc-static-recipes thus we created a
> .bbclass to be inherited.
> See http://cgit.openembedded.org/meta-openembedded/tree/meta-initramfs/classes/klibc.bbclass
>
> Regards
>
> Andrea