[yocto] BeagleBone - uboot & zImage in current master
Maciek Borzecki
maciej.borzecki at open-rnd.pl
Tue Dec 9 06:55:51 PST 2014
Hi,
I'm observing an issue when booting BBB using today's master (Poky
b813bdebb36501500e86fea5f7e15b4b15ea0902). From what I see, default
u-boot config expects a zImage, while the beaglebone.conf sets
KERNEL_IMAGETYPE to uImage.
Also the boot mmc devices seem to be off, the default config has
mmcdev=1, while previously it was 0.
Has anyone observed similar issues?
--
Maciej Borzęcki
Senior Software Developer at Open-RnD Sp. z o.o., Poland
www.open-rnd.pl
mobile: +48 889 117 365, fax: +48 42 657 9079
Niniejsza wiadomość wraz z załącznikami może zawierać chronione prawem
lub poufne informacje i została wysłana wyłącznie do wiadomości i
użytku osób, do których została zaadresowana. Jeśli wiadomość została
otrzymana przypadkowo zabrania się jej kopiowania lub rozsyłania do
osób trzecich. W takim przypadku uprasza się o natychmiastowe
zniszczenie wiadomości oraz poinformowanie nadawcy o zaistniałej
sytuacji za pomocą wiadomości zwrotnej. Dziękujemy.
This message, including any attachments hereto, may contain privileged
or confidential information and is sent solely for the attention and
use of the intended addressee(s). If you are not an intended addressee,
you may neither use this message nor copy or deliver it to anyone. In
such case, you should immediately destroy this message and kindly notify
the sender by reply email. Thank you.
More information about the yocto
mailing list