[yocto] Timeout elimination

[Kurt Stevens]

As for putting the image on a cf card, it may depend on which file system 
you would use.

I am using ext3 on a cf card, following the instructions for installing to a 
hard drive on this page:

 https://wiki.yoctoproject.org/wiki/How_do_I

Luck to you.

"Florin Cristian Dan" 
<dan.florincristian at gmail.com> wrote in 
message 
news:CABzOdpTr4xsWPZtYxwnXOq3XpezVMHULu5Vx9qgxOtKbHt-Gxg at mail.gmail.com...
> Hello, i've managed to burn the BSP image (emenlow) on a usb stick, on
> booted on my target machin, apparently it works fine, but i would like to
> know how can i eliminate that 10 day timeout, i've tried to enter the
> address that is given in the splash http://yoctoproject.org/tlk but is not
> working ("page not found"), this is one question, and another question is:
> currently i'm booting the image from a USB stick, but i want to make it
> defintive and run it from the targets CF memory, the principple of writing
> the image to the CF memory is the same as writing the image for the USB
> stick?
> Thank you very much
> Best regards
>


--------------------------------------------------------------------------------


>