[yocto] Alternative SDK installation directory working?

[Laurentiu Palcu]

Send the reply to the list too. My answer below.

On 11/19/2012 03:06 PM, Jack Mitchell wrote:
> On 19/11/12 12:35, Wolfgang Denk wrote:
>> Hello,
>>
>> I wonder if the installation of the SDK into an alternative directory
>> is actually working?
>>
>> Trying the latest snapshot
>> http://autobuilder.yoctoproject.org/pub/nightly/CURRENT/toolchain/x86_64/poky-eglibc-x86_64-arm-toolchain-gmae-1.3+snapshot-20121119.sh
>> I get this:
>>
>> Installation:
>>
>> -> sh ./poky-eglibc-x86_64-arm-toolchain-gmae-1.3+snapshot-20121119.sh
>> Enter target directory for SDK (default: /opt/poky/1.3+snapshot): /opt/poky-test
>> You are about to install the SDK to "/opt/poky-test". Proceed[Y/n]?Y
>> Extracting SDK...done
>> Setting it up...done
>> SDK has been successfully set up and is ready to be used.
>>
>>
>> Test:
>>
>> -> cat /tmp/x.c
>> int main (void)
>> {
>>          return 0;
>> }
>> -> source /opt/poky-test/environment-setup-armv5te-poky-linux-gnueabi
>> -> ${TARGET_PREFIX}gcc -v -o /tmp/x /tmp/x.c

Just do: $CC -o /tmp/x /tmp/x.c

It should work.

echo $CC
arm-poky-linux-gnueabi-gcc -march=armv5te -marm -mthumb-interwork
-mtune=arm926ej-s --sysroot=/tests/sdk/sysroots/armv5te-poky-linux-gnueabi

Thanks,
Laurentiu

> 
> I think you need a --sysroot in there. e.g. --sysroot=/opt/poky-test/sysroots/arch-blah-blah-blah
> 
>> What am I missing here?
>>
>> Best regards,
>>
>> Wolfgang Denk
>>
> 
> Regards,
>