[yocto] Usb-serial device support

[Leon Woestenberg]

Giovanni,

On Mon, Jul 30, 2012 at 10:48 AM, Giovanni Foiani <fnognn at unife.it> wrote:

> I built a distribution for iMX53 QSB with kernel 2.6.35-3 and I need
> support for USB-serial devices.
> When I plug the usb-serial converter I get this error..
>
> *usb wakeup is here
>
>                           *
> *otg host Remote wakeup
>
>                                            *
> *usb 1-1: new full speed USB device using fsl-ehci and address 3
>
>                                             *
> *usb 1-1: device v067b p2303 is not supported *
>
> I tried to recompile linux-imx kernel adding support for USB-serial
> devices, I run:
>
>    - bibake linux-imx -c menuconfig
>    - added support for usb-serial devices in menuconfig
>    - bitbake -f -c compile linux-imx
>    - bitbake linux-imx
>
> ..but it didn't work..
>
> Any suggestions?
>
> Did you see the install and deploy steps being performed? There are some
versions of OE/Yocto where those steps are not depended upon, even if you
ran -c compile -f.

For example, on Denzil, I have to run the compile, install and deploy steps
forcefully.

Regards,

Leon.

> Giovanni
> --
>
> Dott. Ing. Giovanni Foiani
>
> Cell:        +39-349-3577515
> Phone:    +39-0532-97-4106
> mail:        giovanni.foiani at unife.it
> CenTec - Corso Guercino, 47 - 44042 Cento (FE)
>
>
> _______________________________________________
> yocto mailing list
> yocto at yoctoproject.org
> https://lists.yoctoproject.org/listinfo/yocto
>
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.yoctoproject.org/pipermail/yocto/attachments/20120730/1da9c5fe/attachment.html>