[yocto] Beagleboard SPI

[Jack Mitchell]

A quick shout out to see if anybody has any experience with setting up 
SPI on a BeagleBoard xM Rev C. I have applied patches as stated in the 
eLinux wiki to no avail. Patches are listed below:

I am running kernel 2.6.37 and u-boot 2011.06 and have applied the
following patches:

u-boot for pin muxing:
http://pastebin.archlinux.fr/434099 
<http://www.google.com/url?sa=D&q=http://pastebin.archlinux.fr/434099&usg=AFQjCNFRHAJ90b8iCdCTPiFhHQZDBdSK2g> 


kernel for spidev config and loading of the driver:
http://pastebin.archlinux.fr/434100 
<http://www.google.com/url?sa=D&q=http://pastebin.archlinux.fr/434100&usg=AFQjCNEd7TramfvbJWPN0AfrrgCg07lkIQ> 

http://pastebin.archlinux.fr/434101 
<http://www.google.com/url?sa=D&q=http://pastebin.archlinux.fr/434101&usg=AFQjCNHX768E4py5Y1_k1U0BwiSNQBQIBg>

SPI shows up in /sys but there is no node created in /dev.

If anyone can see any faults or have any suggestions I would love to 
hear them as i'm coming close to bald!

I also have a post listed on the BeagleBoard Google Board:
http://groups.google.com/group/beagleboard/browse_thread/thread/273a51d0ff91537d

Kind Regards,
Jack.


-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.yoctoproject.org/pipermail/yocto/attachments/20110920/d7a9f280/attachment.html>