[yocto] tcf-agent fail to run on imx28evk

[Mark Hatle]

On 9/15/11 8:43 AM, Cui, Dexuan wrote:
> Can you please try to remove “image-prelink" from conf/local.conf’s USER_CLASSES
> and re-build an image to see if that would make a difference?
> 
>  
> 
> Recently looks prelinking was broken and this causes segfaults in some packages.
> 

I believe the latest prelinker update went in this morning (US time).  So try
again and see if that resolves the issue.

To check if you are running the latest version of the prelinker,
meta/recipes-devtools/prelink/prelink_git.bb should reference the SRCREV of
3e3f9b0876aa5ac83a783a95b8bab52cb38ed785

There was a printf issue that was causing things using threading, specifically
thread local storage, to not always prelink properly.  ARM seemed to have
components that were randomly affected.

--Mark

> 
> Thanks,
> 
> -- Dexuan
> 
>  
> 
> *From:*yocto-bounces at yoctoproject.org [mailto:yocto-bounces at yoctoproject.org]
> *On Behalf Of *蔡振军
> *Sent:* Thursday, September 15, 2011 5:27 PM
> *To:* yocto at yoctoproject.org
> *Subject:* [yocto] tcf-agent fail to run on imx28evk
> 
>  
> 
> Hi ALL,
> 
>          I build one image for imx28evk. But tcf-agent fail to start in boot
> process and get same fault when I run it manually.
> 
> Log like this:
> 
>                 /INIT: Entering runlevel: 5/
> 
> /Starting syslogd/klogd: done/
> 
> /Starting tcf-agent: Alignment trap: tcf-agent (1526) PC=0x4e704ca4
> Instr=0xe7913103 Address=0xfffffffe FSR 0x001/
> 
> /Segmentation fault/
> 
> /FAIL/
> 
> /Stopping Bootlog daemon: bootlogd./
> 
>          I have tried to update the version of tcf-agent. Error still exist.
> 
>  
> 
> Best regards
> 
> Feye
> 
>  
> 
>  
> 
> 蔡振军
> 
> 网新技术有限公司物联网事业部
> 
> 杭州天目山路226号网新大厦
> 
> 电话-138 6745 1910
> 
>  
> 
> 
> 
> _______________________________________________
> yocto mailing list
> yocto at yoctoproject.org
> https://lists.yoctoproject.org/listinfo/yocto