[yocto] building and using yocto 1.1

[Mark Hatle]

On 10/28/11 11:13 AM, Xianghua Xiao wrote:
> core2duo E7200 2.53Ghz  4GB 500GB
> 
> 1 thread 1 parallel due to past experience I had from the
> past(parallel make did not work well reliably)

It is a goal of the Yocto Project (and Open Embedded) that parallel building is
full supported, and any identified bugs are fixed quickly.

Enable parallel builds and your performance will be significantly better.

If you have hyperthreading enabled, and setup a 4/4 parallel build.  I would
expect about a 4-5 hour build time.  (May be faster)

--Mark

> thanks,
> xianghua
> 
> 
> On Fri, Oct 28, 2011 at 9:45 AM, Mark Hatle <mark.hatle at windriver.com> wrote:
>> What machine are you using (amount of ram, disk space, and cpu cores)?
>>
>> What configuration did you set for parallel builds?
>>
>> I can build 1.1 on an 8 core i7 system w/ 8 GB of ram, set with parallel
>> settings of 8 thread and 8 parallel make jobs, in about 100 minutes (or less).
>>
>> --Mark
>>
>> On 10/28/11 9:20 AM, Xianghua Xiao wrote:
>>> when I built 1.0 out of the box, it took 7 hours.
>>> on the same machine/network, yocto 1.1 took a full 12 hours, not sure
>>> what happened to cause this nearly doubled build time.
>>>
>>> after the default build(bitbake core-image-sato), I run 'runqemu
>>> qemux86', click on 'tasks', try to add a new task, however my input is
>>> shown non-english, or garbage on screen, which I have seen the same
>>> issue on yocto1.0 release as well. this is a 10.04 ubuntu 64bit
>>> machine.
>>>
>>> don't know what to say about it, just my OOB(out-of-box) experience
>>>
>>> xianghua
>>> _______________________________________________
>>> yocto mailing list
>>> yocto at yoctoproject.org
>>> https://lists.yoctoproject.org/listinfo/yocto
>>
>> _______________________________________________
>> yocto mailing list
>> yocto at yoctoproject.org
>> https://lists.yoctoproject.org/listinfo/yocto
>>