[meta-freescale] Which is the correct BSP to use for a freescale LS1021A-IOT development kit?

[Zhenhua Luo]

Hello Tom,

The meta-fsl-arm layer in Yocto git repo only supports ls1021atwr. To support ls1021a-iot board, you should use the SDK in the NXP official website.


Best Regards,

Zhenhua

From: meta-freescale-bounces at yoctoproject.org [mailto:meta-freescale-bounces at yoctoproject.org] On Behalf Of Thomas A. F. Thorne MEng AUS MIET
Sent: Thursday, July 14, 2016 12:34 AM
To: meta-freescale at yoctoproject.org
Subject: [meta-freescale] Which is the correct BSP to use for a freescale LS1021A-IOT development kit?

Good afternoon,

I have a freescale LS1021A-IOT development board and was wondering if the meta-fsl-arm layer was the correct board support package for it?  I can see the ls1021atwr.conf in  meta-fsl-arm/conf/machine/ which targets the ls102xa chipset so it seems likely to be the correct one.

What makes me wonder if it the correct one is that there is a dedicated ls1021aiot.conf in the meta-fsl-arm layer provided by the LS1021A-IOT SDK found at http://www.nxp.com/products/microcontrollers-and-processors/arm-processors/qoriq-arm-processors/qoriq-ls1021a-iot-gateway-reference-design:LS1021A-IoT?fpsp=1&tab=Design_Tools_Tab

Regards, Tom


--

Thomas Thorne  Software Engineer  Net2Edge Limited
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.yoctoproject.org/pipermail/meta-freescale/attachments/20160714/9b17dddf/attachment.html>