[meta-freescale] Some problems about build yocto project.

[Daiane Angolini]

On Tue, Sep 29, 2015 at 6:02 AM, Li, Xiaojun <Xiaojun.Li at bsci.com> wrote:
> Hi Sir,
>
>
>
> I am trying to build yocto project for i.mx6 under Ubuntu 14.04, there are
> some problems.
>
> Firstly, the below command often failed.
>
> repo init -u git://git.freescale.com/imx/fsl-arm-yocto-bsp.git -b
> imx-3.14.38-6QP_ga
>
> Even if sometimes it can success, but after running “repo sync”, the below
> errors appeared.
>
> error: command 'sync' requires repo to be installed first.
> Use "repo init" to install it here
>
>
>
> I tried to resolve it, but failed. So I downloaded all the source code
> according to default.xml.
>
> And then I run the command “bitbake fsl-image-qt”, you know, there were many
> packages that were downloaded, but when downloading linux
> -imx_3.14.38_6qp_ga.tar.gz, the address
> git://git.freescale.com/imx/linux-2.6-imx.git can’t be accessed. However
> git.freesacle.com can be accessed by Firefox. I can download the tarball
> directly.
>
> I can’t resolve it, so can you give me any advice?

Wait few hours and try again. Then try again. It should be some network hiccup

I assume you have double checked your proxy configuration. Have you?

Daiane
>
> Thank you very much.
>
>
>
>
>
>
> --
> _______________________________________________
> meta-freescale mailing list
> meta-freescale at yoctoproject.org
> https://lists.yoctoproject.org/listinfo/meta-freescale
>