[meta-freescale] Kernel freezes during boot, built from Dora for iMX.6 Quad

[Daiane Angolini]

On Wed, Feb 18, 2015 at 11:39 AM, Isaac Nickaein <nickaein.i at gmail.com> wrote:
> Hi,
>
> I am trying to build Kernel 3.0.35 for my iMX.6Q. I am using Ka-Ro
> TX6Q (http://www.karo-electronics.com/tx6q.html) development kit which
> is compatible with the SabreSD boards.
>
> I've downloaded the Dora branch, set it up for imx6qsabresd board and
> bitbaked core-image-minimal based on this tutorial:
>
> https://community.freescale.com/servlet/JiveServlet/previewBody/95096-102-10-7847/yocto_tutorial.pdf
>
> After flashing the uImage onto the NAND, the kernel freezes at
> "Disabling LCD". Here is the output on the serial console:

Do you have console enabled on your kernel command line?


Why do you need to use such old branch/kernel? If this is "compatible
with the SabreSD boards" I'm sure you´re going to succeed if using
dizzy


Daiane




>
>
>
> U-Boot 2013.07-00115-g828ccd0 (Aug 21 2013 - 11:45:45)
>
> CPU:   Freescale i.MX6Q rev1.2 at 792 MHz
> Reset cause: POR
> Temperature:   48 C, calibration data 0x59c51469
> Board: Ka-Ro TX6Q-1xx0
> I2C:   ready
> DRAM:  1 GiB
> VDDSOC  set to 1420mV
> VDDCORE set to 1420mV
> NAND:  128 MiB
> MMC:   FSL_SDHC: 0, FSL_SDHC: 1
> Invalid color depth: '1120' in video_mode; using default: '24'
> IPU HW Rev: 4
> CPU clock set to 792.000 MHz
> Baseboard: stk5-v3
> MAC addr from fuse: 00:0c:c6:79:aa:6f
> Net:   FEC
> Hit any key to stop autoboot:  0
>
> Loading from nand0, offset 0x180000
>    Image Name:   Linux-3.0.35-4.1.0+yocto+gbdde70
>    Image Type:   ARM Linux Kernel Image (uncompressed)
>    Data Size:    4042436 Bytes = 3.9 MiB
>    Load Address: 10008000
>    Entry Point:  10008000
> ## Booting kernel from Legacy Image at 18000000 ...
>    Image Name:   Linux-3.0.35-4.1.0+yocto+gbdde70
>    Image Type:   ARM Linux Kernel Image (uncompressed)
>    Data Size:    4042436 Bytes = 3.9 MiB
>    Load Address: 10008000
>    Entry Point:  10008000
>    Verifying Checksum ... OK
>    Loading Kernel Image ... OK
>
> Starting kernel ...
>
> Disabling LCD
>
>
> #### serial console output ends here ####
> --
> _______________________________________________
> meta-freescale mailing list
> meta-freescale at yoctoproject.org
> https://lists.yoctoproject.org/listinfo/meta-freescale