[meta-freescale] Reg flashing Yocto SDcard image onto IMX6q sabre sd card

[Shalini K P]

Hi,

     I have prepared an Yocto SD card image "core-image-minimal-imx6q-sabresd.sdcard".  I trying to flash the image onto sdcard using the command
"sudo dd  if= core-image-minimal-imx6q-sabresd.sdcard of=/dev/sdb bs=1M"
Sync
Sync

I m getting the boot messages as below

U-Boot 2014.10+fslc+g5fd0b60 (Apr 03 2015 - 18:55:01)

CPU:   Freescale i.MX6Q rev1.2 at 792 MHz
Reset cause: POR
Board: MX6-SabreSD
I2C:   ready
DRAM:  1 GiB
MMC:   FSL_SDHC: 0, FSL_SDHC: 1, FSL_SDHC: 2
*** Warning - bad CRC, using default environment

No panel detected: default to Hannstar-XGA
Display: Hannstar-XGA (1024x768)
In:    serial
Out:   serial
Err:   serial
PMIC:  PFUZE100 ID=0x10
Net:   FEC [PRIME]
Hit any key to stop autoboot:  1
I m stuck up badly.  It is not going further.  Does the sdcard image contain ü-boot, kernel image and rootfs ? or should I flash u-boot separately ? I even tried flashing both u-boot and sdcaed image. But getting same messages.  Request help in this regard.


Thanks & Regards
Shalini K P

L&T Technology Services Ltd

www.LntTechservices.com<http://www.lnttechservices.com/>

This Email may contain confidential or privileged information for the intended recipient (s). If you are not the intended recipient, please do not use or disseminate the information, notify the sender and delete it from your system.
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.yoctoproject.org/pipermail/meta-freescale/attachments/20150406/4e77e5bb/attachment.html>