[meta-freescale] Flexcan is not working on I.MX 6Q SABRE SD board
Daiane.Angolini at freescale.com
Daiane.Angolini at freescale.com
Fri May 23 06:59:58 PDT 2014
>
> 2014-05-20 14:35 GMT+02:00 Paventhan K <Paventhan.K at lnttechservices.com>:
> > Hi,
> >
> > I am using Freescale I.MX6Q SABRE SD board with revisions
> > SCH-27516 rev C2, 700-27516 rev A. I downloaded the Yocto 1.6(daisy)
> > for Freescale BSP using the following instructions by
> > https://community.freescale.com/docs/DOC-1616.
> >
> >
>
> Finally the flexcan device works in the daisy branch. You have to add
> another entry in the flexcan1 struct: "trx-stby-gpio = <gpio multiplexing
> value to transceiver-standby>;"
>
> Also make sure that you are using the right gpio multiplexing values in
> "pinctrl_flexcan1_1"
> I hope it helps.
Would you mind (pleeeeease) to collect what you needed to get it working in a simple plain text step-by-step?
I would love to have it included in our FSL Community BSP #UG
Thanks in advance,
Daiane
More information about the meta-freescale
mailing list