[meta-freescale] mxs-auart and LED triggers
Stuart Longland
stuartl at vrt.com.au
Wed Jul 16 22:51:37 PDT 2014
Hi all,
Not sure if this is the place to ask or not, I'm currently in search for
the upstream project that looks after the i.MX port of the mainline
Linux kernel.
We're busy building a device for polling energy meters over RS-485, and
one of my colleagues asked if it were possible to use the activity LED
on the unit to indicate RS-485 activity.
Presently, I use it to indicate mmc0 activity. I'm not sure if there's
an equivalent for serial ports.
I did a bit of searching, both for general purpose serial triggers
through to auart-related triggers, nothing seemed to show up.
On a related note, the FlexCAN driver supports turning on/off regulators
when someone brings up or down a CAN interface. Is there an equivalent
facility on mxs-auart that would turn on a regulator when someone opens
a serial port?
Regards,
--
Stuart Longland
Systems Engineer
_ ___
\ /|_) | T: +61 7 3535 9619
\/ | \ | 38b Douglas Street F: +61 7 3535 9699
SYSTEMS Milton QLD 4064 http://www.vrt.com.au
More information about the meta-freescale
mailing list