[meta-freescale] Booting 3.5.7 kernel on imx6sabresd?

[Fabio Estevam]

On Wed, Jan 22, 2014 at 1:06 PM, randy.krakora at freescale.com
<randy.krakora at freescale.com> wrote:
> Ok, so I found the prebuilt images for my board here:
>
> http://autobuilder.yoctoproject.org/pub/releases/CURRENT/machines/imx6qsabresd/
>
> I burned a card with one - core-image-minimal-imx6qsabresd.sdcard. It seemed to work to boot the kernel, so I copied my kernel and .dtb file to that card and it booted as shown below.
>
> reading boot.scr
> ** Unable to read file boot.scr **
> reading uImage
> 4667456 bytes read in 215 ms (20.7 MiB/s)
> Booting from mmc ...
> reading imx6q-sabresd.dtb
> 46128 bytes read in 20 ms (2.2 MiB/s)
> ## Booting kernel from Legacy Image at 12000000 ...
>    Image Name:   Linux-3.5.7-1.0.0+3285970
>    Image Type:   ARM Linux Kernel Image (uncompressed)
>    Data Size:    4667392 Bytes = 4.5 MiB
>    Load Address: 10008000
>    Entry Point:  10008000
>    Verifying Checksum ... OK
> ## Flattened Device Tree blob at 11000000
>    Booting using the fdt blob at 0x11000000
>    Loading Kernel Image ... OK
> OK
>    Using Device Tree in place at 11000000, end 1100e42f
>
> Starting kernel ...
>
> <Hung here for many minutes>

Ok, ,at least now you don't get the CRC kernel error.

Try doing this in the U-boot prompt:

=> setenv fdt_addr 0x18000000
=> save
=> reset

Regards,

Fabio Estevam