[meta-freescale] Change DEBUG console port on SabreSD image

[Niklas Molin]

Hi Fabio.

I'm using 3.10, so I assume it should be setup in the dts then. But I can't
find in any of the dts/dtsi files where to set which UART (and tty) that
should be used for the debug port.

best regards,
Niklas


On Mon, Feb 24, 2014 at 2:18 PM, Fabio Estevam <festevam at gmail.com> wrote:

> On Mon, Feb 24, 2014 at 4:11 PM, Niklas Molin <niklas.p.molin at gmail.com>
> wrote:
> > Thanks for the information.
> >
> > Seems like I was on the right path then.
> >
> > I also tried to change the port for the linux-image (in the defconfig),
> but
> > it seems like it used the "original" settings.
> > I saw something about DEBUG_LL setting, which I could not find the
> > menuconfig (I could se in the defconfig that it was not set).
> > How to enable this, so I can change the DEBUG port in the linux image?
>
> You need to change your board file or dts (if you use 3.10, for
> example) to use uart2 instead of uart1.
>
> Regards,
>
> Fabio Estevam
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.yoctoproject.org/pipermail/meta-freescale/attachments/20140224/b28631cc/attachment.html>