[meta-freescale] [meta-fsl-ppc] Unable to uncompress kernel image

[Arslan, Fahad]

Hi,

I'm getting following error while loading kernel on P1020rdb:

Uncompressing Kernel Image ... Error: inflate() returned -5
GUNZIP: uncompress, out-of-mem or overwrite error - must RESET board to recover

Any idea how we can address this issue?




Complete log is appended below:

U-Boot 2009.11 (Aug 09 2010 - 13:39:52)

CPU0:  P1020E, Version: 1.0, (0x80ec0010)
Core:  E500, Version: 5.0, (0x80212050)
Clock Configuration:
       CPU0:800  MHz, CPU1:800  MHz,
       CCB:400  MHz,
       DDR:333.333 MHz (666.667 MT/s data rate) (Asynchronous), LBC:25   MHz
L1:    D-cache 32 kB enabled
       I-cache 32 kB enabled
Board: P1020RDB
I2C:   ready
SPI:   ready
DRAM:  Configuring DDR for 666.667 MT/s data rate
DDR: 512 MB
NOR Flash Bank : Primary
SD/MMC : 4-bit Mode
eSPI : Enabled
FLASH: 16 MB
L2:    256 KB enabled
NAND:  32 MiB
MMC:  FSL_ESDHC: 0
EEPROM: Read failed.
    eTSEC2 is in sgmii mode.

    PCIE2 connected to Slot 1 as Root Complex (base addr ffe09000)
    PCIE2 on bus 00 - 00

    PCIE1 connected to Slot 2 as Root Complex (base addr ffe0a000)
    PCIE1 on bus 01 - 01

In:    serial
Out:   serial
Err:   serial
Net:   uploading VSC7385 microcode from ef000000
eTSEC1: No support for PHY id ffffffff; assuming generic
eTSEC1, eTSEC2, eTSEC3
Hit any key to stop autoboot:  0
=>
=>
=>
=> setenv ipaddr 137.202.157.70; setenv serverip 137.202.157.152; setenv gatewayip 137.202.157.254;
=> setenv bootargs root=/dev/nfs rw nfsroot=137.202.157.152:/nfsboot/1020rdb/ ip=dhcp console=ttyS0,115200;
=> tftp 1000000 1020rdb/uImage-p1020rdb.bin ;tftp c00000 1020rdb/uImage-p1020rdb-pd_32b.dtb; bootm 1000000 - c00000;
Speed: 1000, full duplex
Using eTSEC1 device
TFTP from server 137.202.157.152; our IP address is 137.202.157.70
Filename '1020rdb/uImage-p1020rdb.bin'.
Load address: 0x1000000
Loading: #################################################################
         #################################################################
         #################################################################
         #################################################################
         #################################################################
         #################################################################
         #################################################################
         #################################################################
         #################################################################
         #################################################################
         #################################################################
         #################################################################
         ###########################################################
done
Bytes transferred = 4291209 (417a89 hex)
Speed: 1000, full duplex
Using eTSEC1 device
TFTP from server 137.202.157.152; our IP address is 137.202.157.70
Filename '1020rdb/uImage-p1020rdb-pd_32b.dtb'.
Load address: 0xc00000
Loading: ###
done
Bytes transferred = 13560 (34f8 hex)
## Booting kernel from Legacy Image at 01000000 ...
   Image Name:   Linux-3.8.13-rt9
   Created:      2014-02-06  10:42:10 UTC
   Image Type:   PowerPC Linux Kernel Image (gzip compressed)
   Data Size:    4291145 Bytes =  4.1 MB
   Load Address: 00000000
   Entry Point:  00000000
   Verifying Checksum ... OK
## Flattened Device Tree blob at 00c00000
   Booting using the fdt blob at 0xc00000
   Uncompressing Kernel Image ... Error: inflate() returned -5
GUNZIP: uncompress, out-of-mem or overwrite error - must RESET board to recover

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.yoctoproject.org/pipermail/meta-freescale/attachments/20140210/bcc29020/attachment.html>