[meta-freescale] Booting Yocto on i.MX35
Daiane Angolini
daiane.angolini at freescale.com
Fri Jun 14 05:23:05 PDT 2013
On 06/14/2013 04:52 AM, Gary Thomas wrote:
> On 2013-06-13 20:19, Daiane Angolini wrote:
>> On 06/13/2013 04:10 PM, Gary Thomas wrote:
>>> I have an i.MX35 PDK that I'd like to run Yocto on. I've built
>>> an SD card image using TARGET=imx35pdk. All went well (past the
>>> small problem of the initial clone of the linux-mainline git
>>> tree - timed out and I downloaded it by hand). However, when
>>> I set the jumpers to boot from SD card, I get continuous errors:
>>> ++NAND: RCSR=b000900
>>> Searching for BBT table in the flash ...
>>> .
>>> Found version 1 Bbt0 at block 8191 (0x7ffc0000)
>>> Total bad blocks: 0
>>> ... Read from 0x07ec0000-0x07f00000 at 0x00080000: ..
>>> ... Read from 0x07eb3000-0x07eb4000 at 0x000bf000: .
>>> PMIC ID: 0x00000010 [Rev: 1.0]
>>> Board version V2.0
>>> Launching POST
>>> Fail, CMD13
>>> Fail, CMD13
>>>
>>> I'll try another SD card when I can get access to one (I'm away
>>> from my office now), but thought I would ask if I've missed something?
>>> Can someone tell me _definitively_ how to set the jumpers for this mode
>>> since the quick start guide and hardware guide don't match??
>>
>> I don't like to rely on my memory. But I remember imx35pdk had a
>> "different" way to set up the switch for internal boot/nand boot/atk
>> boot/whatever.
>>
>> But, from your log, you're booting from NAND (no need to blame your
>> sdcard)
>>
>> Try this one:
>> https://community.freescale.com/docs/DOC-1307
>
> Thanks, that's useful information.
>
> Sadly, when I follow those instructions, the board just sits there with
> no sign of life.
>
> Any ideas what else I might try?
The main problem is that the setup depends on your board version AND
your debug board version.
I'm going to dig into my old documents. In case I find something useful
I let you know.
>
>>
>>>
>>> Thanks for any pointers.
>>>
>>> n.b. I'm also interested if anyone out there has had success with
>>> this setup :-)
>>
>
--
Daiane
More information about the meta-freescale
mailing list