[meta-freescale] Boundary Device's wvga parallel screen touch

[Sandoval Zazueta Francisco-B20593]

I'm trying X11.
There are no more eventX under /dev/input.

I get the following in dmesg:
egalax_ts 1-0004: egalax_ts: failed to read firmware version
egalax_ts: probe of 1-0004 failed with error -5

but I think that's expected, as this display uses a different touch controller.

Thank you for your help!!

-----Original Message-----
From: Angolini Daiane-B19406 
Sent: Wednesday, August 28, 2013 3:04 PM
To: Sandoval Zazueta Francisco-B20593
Cc: meta-freescale at yoctoproject.org
Subject: Re: [meta-freescale] Boundary Device's wvga parallel screen touch

On 08/28/2013 04:03 PM, Sandoval Zazueta Francisco-B20593 wrote:
> Hello!
>
> I found a thread looking around on touch screen working with community
> yocto:
>
> http://comments.gmane.org/gmane.linux.embedded.yocto.meta-freescale/62
>
> I'm trying to get touch to work with the same display on master. Did 
> you figure out the issue? I compiled the kernel with p1003 and 
> irq_set_irq_type. It compiles but touch still doesn't work.
>

Are you trying it for X11 or framebuffer only?


> evtest gives the following output:
>
> root at imx6qsabreauto:~# evtest /dev/input/event0
>
> Input driver version is 1.0.1
>
> Input device ID: bus 0x19 vendor 0x1 product 0x1 version 0x100
>
> Input device name: "gpio-keys"

gpio-keys?


>
> Supported events:
>
>    Event type 0 (Sync)
>
>    Event type 1 (Key)
>
>      Event code 102 (Home)
>
>      Event code 114 (VolumeDown)
>
>      Event code 115 (VolumeUp)
>
>      Event code 139 (Menu)
>
>      Event code 158 (Back)
>
> Testing ... (interrupt to exit)


Do you have another /dev/input/eventX to handle the touchscreen?


>
> With no response with random touches.
>
> Any hints will be appreciated!
>
> Regards,
>
> Paco S.
>
>
>
> _______________________________________________
> meta-freescale mailing list
> meta-freescale at yoctoproject.org
> https://lists.yoctoproject.org/listinfo/meta-freescale
>


--
Daiane